2010 ezgo txt ignition switch b1 wire where does it go

The 2010 Ezgo Txt ignition switch is a powerful and reliable piece of hardware that enables the operation of your golf cart. It has a B1 wire, which is known as the "ground" connection. This wire must be connected to the correct spot in order for the cart to run properly. Where exactly does this wire go?

The answer depends on the type of golf cart your Ezgo Txt is equipped with. If it's an electric-powered cart, the B1 wire should be connected to the starter motor, which is responsible for activating the motor. This connection should be made directly to the negative terminal of the starter motor.

If your Ezgo Txt is a gas-powered golf cart, the B1 wire should be connected to the carburetor. This is done by attaching it to the ground screw located on the carburetor. In some cases, the ground screw may also be found on the chassis.

In any case, it's important to make sure that the B1 wire is securely connected to the right spot. Improperly connecting the wire can cause serious damage to the vehicle, including short-circuiting the electrical system. To prevent this, be sure to consult a qualified mechanic before making any changes to the wiring.

By performing the proper installation of the B1 wire on your Ezgo Txt ignition switch, you can ensure that your golf cart runs smoothly and safely. With the right wiring and a little bit of know-how, you can take the wheel and hit the green with confidence.

Ezgo Key Switch Wiring Diagram Cartaholics Golf Cart Forum